Close the lid and then re-apply power to the printer to complete image drum replacement. Complete the toner cartridge installation by moving the locking lever clockwise.ДЎ0. OKI 44574301 Black Drum Also for use in MF471w MFP and MB491 MFP Supports quality results Compatible with Oki Data B411d, B411dn Works in B431d, B431dn. Reinstall the toner cartridge by sliding forward into the top of the image drum and then pushing down at the front. Remove the remaining packaging (orange plastic) as shown above.Д©. To remove this sheet: release the tape at the top of the sheet and then pull the sheet firmly upwards.ДЁ. A protection sheet has been included to ensure that the image drum surface is not damaged whilst in transit. The image drum has a special alignment pin to ensure that it is correctly installed this should be slid into the appropriate colour coded slot.Д§. Remove the new drum from its bag and place it into the printer. Place the old image drum into the recycling bag provided with the new image drum and return it to OKI Printing Solutions.Д¦. Note: The printer has a special mechanism that allows all of the image drums to be lifted together to allow easier access for clearing paper jams, please ensure that this mechanism is down before removing any of the image drums.ДҐ. Lift the image drum from the printer whilst taking care not to spill any toner that may still be located inside. Keep this toner cartridge safe as it will be returned to the printer once the new drum is installed.Д¤. Lift the toner cartridge up at the front and then pull towards the front of the printer to release it from the image drum. Move the toner locking lever anti-clockwise to unlock the toner cartridge from the image drum and seal its base so that toner does not escape.ДЈ. The toner cartridge sits on top of the image drum and has a locking lever at the front. Select the relevant image drum (C, Y, M or K). 'Shutdown/Restart process' ->ДЄfter the printer has been safely shut down please follow the steps below to replace the Cyan, Yellow, Black or Magenta image drum:Дў. Before replacing any consumables it is necessary to power off the printer using the safe shutdown procedure described in the Knowledgebase article below:

Okidata drum